9.0 Fasteners & Accessories
Fasteners
IMPORTANT
Fasteners used in Structural applications must comply the ENDUROFRAME® Fastener Requirements specification which can be downloaded below.
Fastener Requirements - R2.pdf
Fasteners used should comply with the mechanical properties specified in the /wiki/spaces/EH/pages/35586106. Please check with the manufacturer of frames or the help portal to confirm fastener suitability.
Picture | Description | Application |
---|---|---|
5/16-12 x 17 Hex Washer Trusstite | Primary connection of truss components through pre-punched holes. Both screws listed are suitable for the application. | |
#10-16x16 hex head self drilling screw. | Low strength fixing- ceiling batten fix, chord and web boxing. | |
Wall fastener – M6 x 1P x 15mm Smooth Top GX screw | Connecting wall frame components together through pre-punched holes. Used in ENDUROWALL™ FRAMING SYSTEM, | |
#12-14x20 hex head self drilling screws | General Framing Screw- Roof, Wall and Floor frame installation | |
M6,0 x1P x 18,0 Smooth Top Gx Teks | Stiffening stud to plate connections and connecting lintels to plates | |
M6.5 – 12 x 42 Hex Head Self Drilling Screw | Connecting smart rafters to truncated truss top chords. |
The use of the correct fasteners in the quantities shown in the truss fabrication drawings are essential to ensure the design capacity of the trusses are achieved.
Accessory Components
Product | Base Metal Thickness (mm) | Grade of Steel | Coating |
Angle Lintel | 1.0 | G550 | AZ150 |
Angle Trim | 0.75 | G550 | AZ150 |
Bath Rail | An additional structural member of a wall panel set into studs to provide a recess for a bath. Bath rails are usually factory-fitted but may be supplied loose. | ||
Shower Rail | An additional structural member of a wall panel that is set into the bottom of studs to provide a recess for a shower tray. A shower rail is usually factory-fitted but may be supplied loose. | ||
Accessory | Material | ||
Electrical Grommet | Nylon 6 - Black | ||
Plumbing Grommet | Nylon 6 - Black |